Novinky našich klientov

Upresniť výber:
Späť
Zúžiť vyhľadávanie
Kvalitné ochranné pletené rukavice

máj 18 2021

Nový produkt

Kvalitné ochranné pletené rukavice

Dátum Utorok, 2021, mája 18 17:26

MIRO GLOVES s.r.o. - kvalitné priemyselné pletené ochranné rukavice - vyrobené v ČR !!

Poptejte pre vašej výrobnú firmu pletené ochranné rukavice, vyrobené v ČR z kvalitných materiálov - kupujte priamo u výrobcu. Nami vyrábané rukavice majú certifikáty a oprávnenia o kvalite a bezpečnosti.

- rukavice pre plastikár
- rukavice pre automotive
- rukavice pre strojárstvo
- rukavice pre potravinárov a mäsový priemysel
- rukavice odolné proti prerezu aj.

NAVŠTIVTE NÁŠ E-Schop - www.gloves.cz
Zobraziť viac Zobraziť menej
IPC-2226 Standard for HDI PCB Board Design

máj 6 2021

Iný

IPC-2226 Standard for HDI PCB Board Design

Dátum Štvrtok, 2021, mája 6 7:35

With this article and some others that will follow later we would like to share available knowledge in the PCB design and manufacturing field.

Following some articles related to HDI PCBs we would like to describe the three related more common build-up structures.

HDI PCB types
The design designation system of this standard recognizes industry approved design types used in the manufacture of HDI printed boards. The designations determine the HDI design type by defining the number and location of HDI layers that may or may not be combined with a substrate.

Type I, Standard build-up for HDI
This construction describes an HDI in which there are both blind vias and through vias used for interconnection. Type I constructions describe the fabrication of a single blind via layer on either one or both sides of an PCB substrate core.
The PCB substrate is typically manufactured using conventional PCB techniques and laser via hole technology. The substrate can have as few as one circuit layer or may be as complex as any number of inner layers.

Type II, Sequential build-up 1+N+1
Tipe II is characterized by buried vias in the core and may have through vias through the outer layers. Type II constructions describe an HDI board in which there are plated microvias, plated buried vias and may have PTHs used for surface-to-surface interconnection.
Microvias on layer 1 and layer n grant the connection to conductors on layer 2 and layer n-1, making the connection with the core. Type II constructions can also have PTH to connect layer 1 directly to layer n.

Struttura Tipo III, build-up sequenziale X+N+X
Type III constructions describe an HDI in which there are plated microvias, paste/resin filled holes and through vias used for interconnection. Type III constructions are distinguished by having at least two microvia layers on at least one side of a substrate core. The substrate core is usually manufactured using conventional PCB techniques, may be rigid or flexible, and have as few as one or as many as any number of layers with buried vias.
Where space is minimal and if expressly requested, stacked vias - stacked blind holes - must be used - while where conditions allow it, staggered vias - non-overlapping blind holes on several levels - can be used. Staggered vias are less critical, so preferable, for manufacturing than stacked vias.

For more details, call us +39 059 269711 or send an e-mail sales@cistelaier.com
Zobraziť viac Zobraziť menej
Naspäť hore